![]() Related QuestionsĬan I restore the faded fenders on my Jeep? Yes. The best part however, isn’t just the looks, but rather the fact you can now see out of the windows as you are merging lanes on the freeway.Ĭan you restore the plastic Jeep windows? The answer is yes, and this article provides all the steps I followed to get my Jeep Wrangler’s soft top windows to look great. Your Jeep’s plastic windows will look as if they were new. Putting everything back together and you are good to go. I did find some clear Gorilla glue and touched up the damage. As a note of caution if you have a tear along any edge, don’t hit it with the Dremel wrong, it can make the damage worse. I’m not sure I would use power tools on the entire plastic window though. They actually cleaned up and cleared up well. This allowed me to clean all of the edges. So I broke out a soft polish tip on my Dremel tool (similar to the model below) and turned it to low speed.Īmazon prices last updated on / Affiliate links / Images from Amazon Product Advertising API I found that getting all the way into the corners and along the edges was a challenge for me. This is my own invention and trick which worked really well for me. I guess you could wash the applicators and rags in between each window, but hey who has time for that? If you do decide to wash them, just be sure they are clean. A small grain of sand or something you’ve picked up can do more damage than good. It doesn’t take much to spread small particles (like sand) around. I used a new applicator and new rags for each window. Tapping helps you control the clean edge. When it comes to any kind of car detailing, edges are critical as the lines are where people’s eyes naturally travel. This way I don’t have to worry about keeping the edges clean. So I tape off the windows just as if I were going to paint them. I don’t like how the edges of my soft top fabric look after I get wax or the Meguaris product on them. After the dirt and grime are gone, I then let everything dry and move to the next step, tape. However, I tend to find that the condensation which builds up on the inside is the culprit for most of the clouded look. I don’t want to pick up something that might scratch them worse than they are. I always make sure that I am extra gentle when it comes to cleaning the plastic windows on my Jeep. I used Dawn dish soap as it does a good job of taking the road grease and kids fingerprints off of the plastic. Cleaning the PlasticĪfter I have purchased the and gotten my windows out, the next step is to make sure the surface was clean. I kinda prefer the windows attached for the outside treatment, but I figured I had them out already, just to keep going. I don’t think this is a critical step however, the fact I could get to all the window (at least for the inside) was a benefit for taking the windows off. Removing the windows allowed my to work more comfortably. ![]() In my case only the side windows come off of my soft top model. If you can remove the side and back windows for the restoration project, I would.
0 Comments
Leave a Reply. |